3 x CW5045 stepper motor driver 4.5A 24-50V DC. 1 x 400W 36V 11A DC switching power supply. 1 x 5 axis mach3 breakout board V5 type. 1 x DB25 parallel cable.
Step angle accuracy:+ - 5%(full step, not load). Resistance accuracy: + - 10%. Inductance accuracy:+ - 20%. Temperature rise: 80deg Max(rated current, 2 phase on). Ambient temperature ----------20deg ---- +50deg.Insulation resistance:100ohm Min, 500VDC. Insultion Strength--------500VAC for one minute. DC power input type:24V50VDC. Output current:1.3A-4.5A. Mircostepping:1(1.8º) 1/2,1/4,1/8,1/16,1/32,1/64,1/128,1/256. 1/5,1/10,1/25,1/50,1/125,1/250. Protect form : Overheated protect, lock automatic half current , error connect protect. It is fit for NEMA17-23 two and four phase stepper motors whose current is small than 4.5A, it also can fit for small length NEMA34 two and four phase stepper motors. Full current or half current choice : SW4:0=Full current; 1=half current. To avoid use in the oil contamination, dust and corrosive gas environment. To lay it in a place with good ventilation. Pls note the connection with right power(+ and -) to avoid broken the driver. Pls test it when confirm the connection is right.
5 Axis LPT Port breakout board. It can most connection 5pcs driver and control 5pcs motor in the same time. It is with 4-wire limit switch to insure our safty movement. It is with relay port to contro the cnc spindle. Working voltage is 5VDC and support with MACH3, EMC2, KCAM4 software.
25-pin parallel port control is defined as follows. The pin of the drive board. B(Fifth axis)pulse signal. X(First axis) pulse signal.
X(First axis) direction of the signal. Y(Second axis)direction of the signal. Z(Third axis) pulse signal. Z(Third axis) direction of the signal. A(Fourth axis) pulse signal.A(Fourth axis) direction of the signal. B(Fifth axis) direction of the signal. 400w 36v dc Switching power supply. 400W, Input:100-120VAC or 200-240VAC, 50/60Hz, Output:36v/9.7 A, single output switching power supply. Item must be in it's original condition and no physical damage. We are happy to have your questions. We are here to solve them by the friendly and quick ways.
The item "EU 3 Axis Nema23 Stepper Motor Driver Breakout Board Mach3 CNC Controller Kit" is in sale since Monday, August 3, 2020. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Drives & Starters\Drives & Motor Controls\Stepper Controls & Drives".The seller is "kuku218" and is located in Frankfurt. This item can be shipped to European Union member countries.